Complete Air Cup Kit with 14mm Front Cups

More Views

Complete Air Cup Kit with 14mm Front Cups


From £18.32 a month on finance (based on £640.00 Purchase) *Subject to Terms and Conditions
From £18.32 a month on finance (based on £640.00 Purchase) *Subject to Terms and Conditions
Worldwide Shipping Get a quote

For those people that want to run proper coilover suspension with the ability to lift the car over obstacles; The future is here!

The Stanceparts Air Cup Kit includes everything you need to install the air cup lift system:
• 2 air cups
• 12 meters of airline & T-splitter(s) (To suit both Front and Four-corner setups)
• 12v 3-way valve + switch and 5 meters of wire
• Complete VIAIR compressor kit with 2 gallon tank.
• Instructions Booklet

This kit will fit the current design of HSD kits for the following models:
(If you already own a HSD kit, please measure your current shaft diameter to confirm application)

Mazda MX5 MK1 NA6C/NA8C 89-97 - HSD Monopro
Mazda MX5 Mk2 NB6C/NB8C 98-05 - HSD Monopro
Mazda MX5 Mk3 NC8C 06+ - HSD Monopro
Mazda RX8 03+ - HSD Monopro

If you have any queries regarding air cup fitment, be sure to contact us!

2 year warranty on the air cups.
1 year warranty on the compressor setup, covered by the manufacturer: VIAIR.

Air cup Kit!
14mm Shaft Diameter Air Cups [Pair]


These Stanceparts air cup kits will fit a lot of coilover kits with the exception of some large diameter inverted dampers. - Get in touch if you're unsure about your kit.

The kit sits between the main spring and the spring top cup on the coilover and is just 20mm when not inflated. At full extension the cups measure approximately 70mm, so provide approximately 50mm of lift. 
Stiff spring rates can reduce how much the kit lifts, and helper springs or spring droop are sometimes recommended when fitting these cups, so they are not fighting the main spring rate too much in addition to the weight of the car.

When used with HSD & Driftworks Coilovers we have a variety of parts & springs available, so will do our best to assist in making this kit work correctly as best as possible. With other coilover brands additional parts may be required that we may not be able to source.

The air cups should fit any brand of coilovers, as long as they meet the requirements below.
Make sure the dimensions match your coilover, we strongly recommend to measure with a caliper. You will also need to ensure you have adequate clearance on your car to support the cups.


measurements Springs
• The outer diameter must be less than 99mm.
• The inner diameter must be 61 mm or more.

Coilover shaft
• Measure the thickest part of the coilover shaft. Kits are available for coilover shaft diameters:12,5mm, 14mm, 15mm, 16mm, 18mm, 20mm and 22mm



Linear springs
The air cup lift system will only fit on linear springs, it will not fit on ''shaped'' springs as shown in the figure. If you have ''shaped'' springs, it's often possible to install linear springs.

High spring rates
If you're using extreme high spring rates, higher than the original rates that came with your coilovers, then it's possible that you can't use the full 50mm lift from the air cups. Due to the extreme high spring rates, the weight of the car won't compress the springs and damper enough to create a stroke for the air cups to lift. This can be solved by using helper springs. 



• The diameter of the air cup is 120 mm.
• The fitting is 17mm.

The air cup is only 20mm thick in the lowest position. Depending on your coilovers and vehicle, the air cups will generally take up 20 to 30mm of space. If you have enough travel left on your coilovers to lower it, this won't be a problem. If not, you can install shorter springs to compensate.



The air cup is mounted on the top of the spring and just acts like a spacer. When you put pressure in the system, the air cup will expand and the car will raise up to 50mm. The air cup lift system does not affect the ride quality and performance of your coilovers.

• Max total car weight: 2000 kg / 4400 lbs (or max axle weight: 1300 kg / 2850 lbs)

Shipping Price

Shipping Price

We ship worldwide!
  • Yes No

Finance Calculator


5.00 Average

1 Reviews

Joanna Camilleri

Great kit with all required hardware looking forward to finish installation

Get the latest product releases & offers...